The wire beam processing needs to be done in every way.
Posted On:2017-12-07 9:24:40
Wire-beam processing plant: It is necessary to do a good job in all aspects of wire beam processing. In the process of wire beam processing and production, it is necessary to do a good job in the inspection of the appearance and diameter of the line to ensure the quality of the line and strictly control all aspects of production and processing. To ensure that the wire beam processing in the production process in accordance with national standards, through its line inspection and quality control to achieve the purpose of efficient production and processing.
Place a piece of white paper in one hand at a distance of 1-2 cm from the copper wire. Place the cable shaft full of copper wire on the packing table. The other hand rolls the shaft of the copper wire for a week, Whether or not its appearance meets the following specifications: smooth appearance, no black line, no chaos line, no point, no oxidation, no hitting, no scratch, no tin-plated bad sticky tin, no slant, no hand joint, no handprint. Good alignment, uniform, no pile edge, low edge on the upper edge or low stock on both sides. Tension moderate but loose or too tight. After rolling, the surface of the copper wire is free of sticky ash.
In the process of production of wire beam processing, we should do a good job in the quality control standards for this link, use a series of inspection and measurement standards, and analyze the status quo to ensure that the wire beam processing does all the work well and control the quality of production from the source. Improve the efficiency of wire beam processing, and do a real high efficiency, high quality production.
WeChat ID:JF87216
Mailbox: olt@wzparts.com
Fax: 0577-66005661
Address: NO.199Fengdu 1st,Road Luo feng Industrial Industrial Zone, Tang Xia Town, Ruian, Zhejiang
Mobile phone: 13958887216 15606666868
Address:NO. 5, Laoxiahe Road, Hexian County Economic Development Zone, Ma'anshan, Anhui